This question is about transmission lines and matching
(a) Given a 9-volt source with impedance Rs = 25Ω is connected to a transmission line with Z0 = 50Ω, length = 0.1m and Vp = 1*108 m/s followed by a load ZL = 75Ω calculate.
⦁ (i) The initial voltage on the line.
[1 mark]
⦁ (ii) The voltage at the load after 5T (where T is the time taken to travel from one end of the line to the other), sketch a bounce diagram
⦁ (iii) The voltage the line will settle to.
⦁ (iv) When and why are transmission lines required?
Question 2 continued
(b) Given the PCB mounted 200MHz chip antenna shown in Figure 2 and a measured value of 20+70j design an L match. State all assumptions.
Matching circuit
Length =7.2cm
Figure 2 PCB chip antenna with matching area.
Sun | Mon | Tue | Wed | Thu | Fri | Sat |
---|---|---|---|---|---|---|
1 | 2 | 3 | 4 | 5 | 6 | 7 |
8 | 9 | 10 | 11 | 12 | 13 | 14 |
15 | 16 | 17 | 18 | 19 | 20 | 21 |
22 | 23 | 24 | 25 | 26 | 27 | 28 |
29 | 30 | 1 | 2 | 3 | 4 | 5 |